Table of Contents
Advertisement
I.
II.
III.
a-Location
IV.
V.
SERIAL
VOLTS
TOTAL CURRENT
MINIMUM CIRCUIT
MAXIMUM OVERCURRENT PROTECTION
LIGHTS
HEATERS
REFRIGERANT
DESIGN PRESSURE
REFRIGERANT
DESIGN PRESSURE
TABLE OF CONTENTS
Page 1
Page 2
Page 2
Page 2
Page 2
Page 2
Page 3
Page 3
Page 3
Page 3
Page 3
Page 3
Page 3
Page 3
Page 3
Page 3
Page 4
Page 4
Page 4
Page 4
Page 4
Page 5
Page 5
Page 5
FORT WORTH, TX.
MODEL
Hz
PH
AMPS
AMPS
WATTS
AMPS
TYPE
HIGH
TYPE
HIGH
370-60294-00 REV (A)
a-Introduction
X.
XII. WIRING DIAGRAM - MODELS RET232NUT ONLY
XIII. WIRING DIAGRAM - MODELS RET232EUT ONLY
I. THE SERIAL TAG
The serial tag is a permanently affixed sticker on
which is recorded vital electrical and refrigeration data
about your Traulsen product, as well as the model
and serial number. This tag is located in the upper
right interior compartment on all reach-in/pass-thru
and roll-in/roll-thru refrigerator, freezer and dual-temp
models. For hot food models, this tag is located on
the top of the unit behind the louvers to protect it
AMPS
from the heat.
READING THE SERIAL TAG
OZ
LOW
• Serial = The permanent ID# of your Traulsen
• Model = The model # of your Traulsen
OZ
• Volts = Voltage
LOW
• Hz = Cycle
• PH = Phase
• Total Current = Maximum amp draw
• Minimum Circuit = Minimum circuit ampacity
• Lights = Light wattage
• Heaters = Heater amperage (Hot Food units only)
• Refrigerant = Refrigerant type used
• Design Pressure = High & low side operating
pressures and refrigerant charge
• Agency Labels = Designates agency listings
-1-
Page 5
Page 5
Page 5
Page 6
Page 7
Page 7
Page 7
Page 7
Page 7
Page 7
Page 7-8
Page 8
Page 9
Page 10
Page 11
Page 12
Page 13
Page 14
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
