J-1000™ Remote Control - Jacuzzi J-400 Series Installation Manual And Use & Maintenance

Power Button
2.
Press power button once to turn on stereo system. Press a sec-
ond time to place the stereo in "Standby" mode and the red light
will remain illuminated.
3. Auxiliary Input Jack Connector
Allows you to connect an auxiliary device by using a 3.5 mm cable.
4. Universal Serial Bus (USB) Device Connector
Allows you to connect your device via a USB port and a USB ca-
ble compatible with your device.
5. Auxiliary Device Holding Base
The removable base securely holds the Auxiliary device, in place.
It can be removed for larger devices.
6. 3.5 mm Cable (purchased separately)
Use this cable to connect your Auxiliary or MP3 device to the
stereo via the "AUX" connection.
7. Apple 30-pin to USB Cable (purchased separately)
Use this cable to connect your compatible iPod, iPhone or MP3
device to the stereo via the "USB" connection.
Note: Digital Rights Management (DRM) Files cannot be
played on this deck. Personal files (MP3, WMA, iTunes or
AAC) can be played as long as they are not DRM encrypted.
WARNING: RISK OF ELECTRICAL SHOCK HAZARD
EXISTS AND EQUIPMENT DAMAGE! Never install or re-
move electrical devices while hands are wet or while sitting par-
tially or fully immersed in the spa!
CAUTION: Never leave electrical devices in the Media Locker
when spa is not is use to prevent damage from outdoor elements!
Never spray Media Locker with a pressurized water hose for any
reason! Damage to the device or spa stereo system caused by
water intrusion is not covered under the manufacturer's war-
ranty! Damage to Media Locker port or electrical devices due to
excessive force or improper alignment during installation or re-
moval from Media Locker is not covered under warranty.
J-1000™ REMOTE CONTROL
Most parts of the functions can be managed through this re-
mote control whose main characteristics are:
- when turning on, the remote control will check the correct
communication with the spa control unit; a control procedure
that individuates the various active functions (that are indicated
on the remote control display itself) will start. The water tem-
perature and the main menu are also shown.
- if the remote control remains unused for a period of approx-
imately 15 seconds it will be turned off automatically; press
any button to reactivate the remote control (the display and the
keypad will light up).
Note: the remote control is water resistant (but not water
tight); store in a dry place when not in use . Do not leave in
the spa underneath the cover.
Symbols legend
Filter Boost
indicates that the spa functions are blocked (may be
unblocked via the control panel only).
Temperature setting.
Time setting
Heating
Lighting system.
light colour cycle.
Pump 1
1
Pump 2
2
Pump 3
3
flat battery
FM
FM frequency (radio mode).
USB
USB mode (check that the device is attached).
AUX
AUX mode (check that the device is attached).
BT Bluetooth (check that the device is attached).
BT
"Return" key
67
BT