Underwater Spotlight/Spotlights; Utility Functions; Control Panel Lock; Partial Lock - Jacuzzi Experience Alimia Installation Manual

on, if it was not already. It will remain on for 10 minutes after
the function is turned off.
I

UNDERWATER SPOTLIGHT/SPOTLIGHTS

The digital LED lighting system can be turned on using the key
on the control panel.
Press the "Light"
The spotlight will stay on for two hours, but it can be turned
off before that by pressing the key again. Refer to the user's man-
ual for the operation of the various sequences of colours.
NOTE: when you turn on the spotlight, the filtering pump is al-
so turned on, as there is probably someone in the tub. It stays
on for 10 minutes after the spotlight is turned off.
For models with two spotlights, the on/off control acts on both
spotlights.

Utility functions

I

CONTROL PANEL LOCK

There are two modes for this function:
- Partial lock: this makes it impossible to programme the filtering
cycle. You also cannot activate the energy savings mode (Econo)
and rapid filtering ("Instant Clear").
All other control panel keys remain active.
- Total lock: this mode prevents operation.

Partial lock

To activate this function:
Press and hold the key "Econo"
symbol for the locked panel will flash on the display (
tinue holding the key until the message "LocP" appears and the
symbol stays on steady, which indicates that the lock has been
activated.
If you press a key whose use is not permitted, the display will
show the message "LocP" for five seconds.

Total lock

To activate this function:
Press and hold the key "Econo"
locked panel will flash on the display (
key even after the message "LocP" appears, until the message
"LocF" appears. The function is now active.
If you press any key, the display will show the message "LocF"
for 5 seconds.
key to turn on the spotlight.
for a few seconds. The
. The symbol for the
). Continue holding the

De-activating the lock

In both modes, to de-activate thelock, press and hold the key "E-
cono" until the message "LocP" or "LocF" disappears and is re-
placed by the message "ULoc".
NOTES
- If their is a power outage, the keyboard lock (either partial or total)
is removed.
- If you want to change for partial lock to total lock (or vice-versa), y-
ou must first deactivate it and then set the new lock mode.
I
TEMPORARY SYSTEM SHUTDOWN
("STANDBY")
This function lets you suspend operation of all system devices for a peri-
od of 60 minutes (this value cannot be changed) so that you can per-
form routine maintenance without having to disconnect the power sup-
ply.
ATTENTION
If you need to access the electrical parts, parts which
are normally powered, or the rotating parts of the
pumps, you must turn off the omnipolar switch(es).
To activate the function, press and hold the "Filter"
about 5 seconds: the display will show the message "Sby" followed
by the number of minutes the function will remain active.
The function ends when the 60 seconds are up, or by pressing and
holding the "Filter"
cles which had been suspended will resume operation, as programmed.
NOTE: if filtering cycles are active at the end of the standby condi-
tion, they will restart.
Management of functions
by means of pneumatic push buttons
). Con-
The buttons that are supplied (which should be installed near the
spa, within reach of the user) are used to manage the following
functions:
- Hydromassage pump 1
- Hydromassage pump 2 (if present)
- Blower (if present in the system).
- Underwater spotlight(s)
p2
p1
34
key for another five seconds. Any filtering cy-
b
f
f
p1
key for