Table of Contents
Advertisement
Frequently Asked Questions
/FAQ
Why does the Lucca need GPS reception?
The Lucca needs GPS reception to determine
its position. It receives information both on
its location and direction of travel from the
GPS satellites. This is what enables the Lucca
to safely guide you to your destination.
Why does the Lucca have diffi culties
receiving GPS signals?
The Lucca needs approx. 1 minute before
it is ready for navigation after having been
turned on. When turned on for the fi rst time,
it will need a little longer as well as a very
strong GPS signal.
Tall buildings, trees and even an awkward
installation location in the vehicle can
obstruct GPS satellite signal reception.
Changing the Lucca's location while the unit
is turned off (e.g. after having been carried
on a plane or train) can cause the Lucca
to be unable to receive GPS signals for a
longer period of time.
What can I do when the Lucca has problems
receiving GPS signals?
If the Lucca has trouble receiving GPS
signals, go outside, place it onto an elevation
and do not move it. Your Lucca should be
ready to operate again within 2 to 5 minutes.
The Lucca will now also be able to navigate
if conditions are less than ideal.
Lucca's status can be viewed in the
Navigation menu > GPS Info menu.
Why doesn't the battery last longer?
The Lucca's memory and GPS receiver
continue to use power – even though only a
marginal amount – when turned off. This is
why the Lucca's battery may be discharged
within a couple of days of recharging it.
Short journeys are not suffi cient to fully
recharge the battery. This is why you
should always connect the Lucca to your
vehicle's battery using the cigarette lighter
charging cable when using it in your vehicle.
The batteries must be fully charged (by
recharging them for approx. 5 to 6 hours)
to achieve the maximum battery run time of
up to 3 hours.
What is the type of data I can store on a
SD-/MMC card for use with the Lucca ?
You can use SD-/MMC cards with a capacity
of up to 4 GB. Lucca will recognise the
following data:
•
Operating
system
material
•
MP3-/WMA data for playing music back
using the Music Player
•
JPG data for viewing images using the
Picture Viewer
What are the SD-/MMC card fi le format
requirements?
FAT16 or FAT32.
What kind of memory cards are suitable for
use with the Lucca?
The Lucca is designed for use with
conventional SD- or MMC cards. However,
there is always the possibility that a
particular type of SD-/MMC card proves
to be incompatible with the Lucca. In this
event, simply reformat the card to FAT32.
If the Lucca still fails to recognise the SD-
/MMC card after reformatting, please try a
different brand SD-/MMC card.
Is it also possible to use other cartographic
material with the Lucca?
Yes. Simply put the SD-/MMC card with the
cartographic material into the SD-/MMC card
slot and access the new data for navigation.
Lucca always uses the cartographic material
stored on the SD-/MMC card and the data in
its memory to navigate.
Can I also use cartographic material from
other Lucca models?
No. The Lucca 3.3 EE can only be used with
the cartographic material originally supplied
on the DVD/CD or cartographic material
sold specifi cally for this model/version.
Is it possible to restore the navigation
software in the Lucca's memory?
Yes. The navigation software is provided
on the supplied DVD/CD. The data can be
transferred to an SD-/MMC card through
the USB connection. The data can then
be downloaded into the Lucca's memory
from the SD-/MMC card. Please refer to
the instructions on the DVD/CD for more
information.
FAQ
and
cartographic
43
Advertisement
Table of Contents
