Ryobi RBV254O Original Instructions Manual page 26

OPERATION
4. Set the choke lever to "FULL" position.
Squeeze the throttle trigger. Pull the
throttle lock backward.
5. Hold the product with one hand and use
your other hand to insert the starter drive
shaft into the blower starter housing.
Make sure the starter bit is properly
engaged. Press and hold the electrical
starter switch button until the engine
attempts to start. Do not press the
electrical starter switch button for more
than 4 seconds.
6. Set the choke lever to the "HALF" choke
position. Press and hold the electrical
starter switch button until the engine
starts. Do not press the electrical starter
switch button for more than 4 seconds.
7. Allow the engine to warm up for 20
seconds prior to operation. To stop the
engine, toggle the on/off switch to the
"STOP" position.
26
4
1
5
1
6
1
7
2
3
2
2
2
1
2
4s 4s
4s 4s