Configuring The System In Offline Mode; Overview - Siemens SIMOTION D410 Series Commissioning Manual

4.2

Configuring the system in offline mode

4.2.1

Overview

Introduction
You can decouple commissioning of the drive from the system engineering. This enables
you to configure the system offline (in the office), e.g. configure the drive and create a virtual
axis. In this way, a SIMOTION project can be developed to the point that there is a basic
project specification (including a program). You can then download the finished project to the
SIMOTION D410. Any errors that were made during configuration can be cleaned up during
online operation (using a desired/actual comparison of the SINAMICS topology).
Prerequisites for offline configuration
● All components and their order number must be known for the offline configuration.
● You created a project in SIMOTION SCOUT and added a SIMOTION D410 to the project.
● You configured the communication between the programming device / PC and
Procedure
Steps involved in offline configuring:
● Calling the Drive Wizard
● Configuring components
● Aligning the HW Config
● Downloading the project to SIMOTION D410, by means of the following options:
Note
During offline configuration, you can configure Terminal Modules such as the TM15, for
example.
D410
Commissioning Manual, 05/2009
SIMOTION D410.
– Downloading to the target system
– Downloading to the CompactFlash Card
– Downloading incl. sources and additional data
Commissioning (software)
4.2 Configuring the system in offline mode
59