Testing The Configured Drive Using The Drive Control Panel - Siemens SIMOTION D410 Series Commissioning Manual

Commissioning (software)

4.5 Testing the configured drive using the drive control panel

4.5 Testing the configured drive using the drive control panel
You can test a configured drive using the drive control panel where you can define a speed
value by setting a scaling factor. The drive control panel should only be used for
commissioning.
Prerequisites
● The project has been downloaded to the target system.
● SIMOTION SCOUT is in online mode.
● The drive is not in use by a current project in RUN mode.
Testing the drive using the drive control panel
1. Change to the configured drive in the Project Navigator and open the drive control panel
Figure 4-17
2. To display the control range and axis diagnostics, click the "Show/hide control range" and
86
WARNING
Make sure that the drive test does not pose any risk to persons.
by selecting "Commissioning" > "Control panel". The drive control panel opens in the
detail view.
Drive control panel
"Show/hide diagnostics area" buttons.
D410
Commissioning Manual, 05/2009