Mode Setting For Re-Print Signal (Input) - Epson CW-C6000 Series Technical Reference Manual

Mode setting for re-print signal (input)

[Format]
^S(CNI,R,c
[Parameter] c
Description
c = Mode setting
[Function]
Configure the mode settings for the re-print signal.
Value for parameter c
0
1
[Initial value]
0
[Examples of command transmissions]
Set the re-print signal to "Reprint labels when a Low signal is input for 20 msec or longer".
The ^JUS command must be used to save the settings to the non-volatile memory in the printer.
An example of the command transmission is shown below. It is sent via USB or Ethernet from the computer.
^XA
^S(CNI,R,1
^JUS
^XZ
0/1
Ignore the re-print signal (pin 13).
Set the re-print signal (pin 13) to the following mode: Reprint the previously printed label
when a Low signal is input for 20 msec or longer.
Definition range
Description
Chapter 3 Commands
3
37