Mode Setting For Clogged Nozzle Check Signal (Input) - Epson CW-C6000 Series Technical Reference Manual

Mode setting for clogged nozzle check signal (input)

[Format]
^S(CNI,D,c
[Parameter] c
Description
c = Mode setting
[Function]
Configure the mode setting for the clogged nozzle check signal.
Value for parameter c
0
1
[Initial value]
0
[Examples of command transmissions]
Set the clogged nozzle signal to "Check the nozzles when a Low signal is input for 20 msec or longer".
The ^JUS command must be used to save the settings to the non-volatile memory in the printer.
An example of the command transmission is shown below. It is sent via USB or Ethernet from the computer.
^XA
^S(CNI,D,1
^JUS
^XZ
34
0/1
Ignore the clogged nozzle check signal (pin 14).
Set the clogged nozzle check signal (pin 14) to the following mode:
Check the nozzles when a Low signal is input for 20 msec or longer.
Definition range
Description