System Board - HP 200 G4 22 Maintenance And Service Manual

System board

1. Prepare the computer for disassembly
2. Remove the display (see
3. Remove the fan (see
4. Remove the heat sink (see
5. When replacing the system board, be sure that the following components are removed from the
defective system board and installed on the replacement system board:
Memory modules
●
M.2 solid-state drive
●
WLAN module
●
6. Disconnect the following cables from the system board (as applicable):
(1) Camera module
(2) Power button/card reader board
(3) Left speaker
(4) Right speaker
(5) Optical drive (select products only)
(6) Hard drive (select products only)
(7) Hard drive (select products only)
7. Remove the seven Phillips screws (1) that secure the system board to the computer.
(Preparation for disassembly on page
Display on page 18).
Fan on page 26).
Heat sink on page
(Memory on page 19)
(Solid-state drive module on page
(WLAN module on page 27)
33).
24)
16).
System board 35