HP 200 G4 22 Maintenance And Service Manual page 72

Out of memory error.
Cause
You have run out of memory to run the application.
Memory count during POST is wrong.
Cause
The memory modules may not be installed correctly.
Integrated graphics may use system memory.
Insufficient memory error during operation.
Cause
Too many Terminate and Stay Resident programs (TSRs) are
installed.
You have run out of memory for the application.
Power LED flashes Red five times, once every second, followed by a two second pause, and the computer beeps five times. (Beeps
stop after fifth iteration but LEDs continue flashing.)
Cause
Memory is installed incorrectly or is bad.
62 Chapter 6 Troubleshooting without diagnostics
Solution
Check the application documentation to determine the memory
requirements.
Solution
Check that the memory modules have been installed correctly and
that proper modules are used.
No action required.
Solution
Delete any TSRs that you do not need.
Check the memory requirements for the application or add more
memory to the computer.
Solution
1. Reseat SODIMMs. Power on the system.
2. Replace SODIMMs one at a time to isolate the faulty module.
3. Replace third-party memory with HP memory.
4. Replace the system board.