Solid-State Drive Module - HP 200 G4 22 Maintenance And Service Manual

Solid-state drive module

For a list of available solid-state drives, see
1. Prepare the computer for disassembly
2. Remove the display (see
3. Remove the larger Phillips screw (1) and the smaller Phillips screw (2) that secures the drive bracket,
and then remove the bracket from the computer (3).
4. Pull the drive away from the connector.
If you are installing a combination solid-state drive and Optane memory module:
1. Install thermal pads on both the bottom (1) and top (2) of the drive.
24 Chapter 4 Removal and replacement procedures
Computer major components on page
(Preparation for disassembly on page
Display on page 18).
4.
16).