Epson Stylus COLOR 900 Service Manual page 111

EPSON Stylus COLOR 900/900N
4.2.8.8 ASF Sensor Removal
1. Remove the ASF unit. (See
2. Remove the right hopper release cam.
Roller Shaft
Hopper Release Cam (Right)
Figure 4-33. Removing the Hopper Release Cam
C H E C K
During assembly, match the orientation of the
P O I N T
right hopper release cam with that of the left
one.
page 103.)
Chapter 4 Disassembly and Assembly
3. Remove the E-clip located just to the inside of the left hopper
release cam, as shown below.
E-Clip
ASF Roller Shaft
Figure 4-34. E-Clip Removal
4. Slide the shaft to the left as far as it goes.
5. Remove the detection wheel by releasing the tab that secures it to
the left end of the shaft, as shown below.
Figure 4-35. Detection Wheel Removal
C H E C K
During assembly, make sure that the hole in the
P O I N T
detection wheel faces the same direction as the
hopper release cam.
Roller Shaft
108