Table of Contents
Advertisement
(3)
RJ45 Over USB Port connector: UL1
The connectors are 4-pins connector that connect USB devices to the system board,
and standard RJ45 connector for Network supports 10/100 BASE-T transfer rate.
(4)
Serial Port Connector (9-pin female): VGA_COM1
Serial Port connector is a 9-pin D-Subminiature connector. The On-board Serial Port
can be disabled through the BIOS SETUP. Please refer to Chapter 3 "INTEGRATED
PERIPHERALS SETUP" section for more detail information.
(5)
VGA Connector (15-pin female): VGA_COM1
VGA Connector is a 15-pin D-Subminiature Receptacle connector.
This connector is for connection Monitor and System to display.
(6)
Audio Connector: CN4 (Line-Out/ Line-IN/ MIC)
This Connector are 3 phone Jack for LINE-OUT/ LINE-IN/ MIC.
Line-out :
Line-In :
MIC :
(7)
IEEE 1394 Port Connector: U11
(8)
Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to your hard disk(s).
If you install two hard disks, you must configure the second drive to Slave mode by
setting its jumpers accordingly. Please refer to the documentation of your hard disk for
the jumper settings.
•
Two hard disks can be connected to each connector. The first HDD is referred to as the
"Master" and the second HDD is referred to as the "Slave".
Audio output to speaker
Audio input to Audio controller
Microphone Connector
PS/2
COM1
MOUSE
PS/2
VGA
Keyboard
IDE 1
LAN
USB
Pin 1
13
Optional
IEEE1394
LINE IN
LINE OUT
MIC
Advertisement
Table of Contents
