Step2 Hold Down [Ptt] To Transmit; Troubleshooting - Icom ID-51A Basic Instructions

New2001 New2001
Push D-pad( !) to select "25:
e
Simplex," and then push D-
pad(Ent).
Push D-pad( !) to select
r
"433.450," and then push
D-pad(Ent).
"FROM."
- If a station call sign is set in
"TO", select "Local CQ" in the
TO SELECT screen to set
"TO" to "CQCQCQ."
New2001
8

TROUBLESHOOTING

To communicate through the repeater, your signal must access to the repeater. When your signal accesses your local repeater,
but it is not sent to the destination repeater, the repeater replies with an status message.
PROBLEM
After your call, the repeater does
not return a status reply.
After your call, the repeater re-
plies 'UR?' and its call sign.
After your call, the repeater re-
plies 'RX' or 'RPT?' and the ac-
cess repeater's call sign.
After your call, the repeater re-
plies 'RPT?' and call sign of the
destination repeater.
After your call, the access repeat-
er replies 'RPT?' and its call sign.
35
POSSIBLE CAUSE
er.
immediately replied.
istered on a gateway repeater, or the regis-
tered contents do not match your transceiv-
er's setting.
tion repeater.
busy.
wrong.
MAKING A SIMPLEX CALL
STEP 2 Hold down [PTT] to transmit
While holding down [PTT],
q
level.
transmit output power level.
Release [PTT] to receive.
w
the VFO mode, the LCD chang-
es as shown to the right.
NOTE: The simplex frequencies can be changed in the
MENU screen. See the PDF type Advanced Instruction
(MENU > DV memory > Repeater List)
SOLUTION
offset, or duplex setting.
-
try again.
-
way repeater, or confirm the registration of
the call sign.
-
Wait for a while, and try it again.
sign.
7
Transmitting
7
34
New2001
REF.
p. 17
—
—
—
p. 2
- p. 4
p. 17
—
—