Filter Orientation; Gun Arm Bracket Mount - Graco RoadLazer RoadPak 24G677 Operation

Filter Orientation

After mounting and securing the RoadPak to the vehi-
cle, position the filter assemblies as desired.
1. Use a hammer to loosen the large jam nut on the
pump assembly.
ti16782a
2. Rotate the filter assembly to the desired orientation
and use a hammer to tighten the jam nut and lock
the assembly into place.
ti16784a

Gun Arm Bracket Mount

Single Hitch Mounting Bracket (24G626)
Installation (Option 1)
1. Install hitch insert bracket (A) into receiver (C).
Ensure hitch pin (B) goes through tightening rod
hole (D).
ti16648a
A
D
3A1214D
ti16783a
ti15839a
C
B
ti15955a
2. Tighten nut until the hitch insert bracket is pulled
securely to the receiver and no play is seen
between the two parts.
3. Install the height adjustment bracket (303) to the
hitch insert bracket with bolts (312), washers (307),
and nuts (315). Ensure the height adjustment
bracket is installed level.
303
4. Install stow bracket (302) to height adjustment
bracket (303) with bolts (312), washers (307), and
nuts (315). Locate the bottom of the stow-bracket
21-in. to 25-in. (53cm - 63cm) from the ground.
Ensure the stow-bracket is installed level.
302
ti16785a
315
307
307
312
ti15956a
315
307
312
302
21 in. - 25 in.
(53 cm - 63 cm)
ti15957a
Setup
9