Table of Contents
Advertisement
82
C
8: P
HAPTER
ERSONALIZING
Using a Headset
With the NBX 3102
Business Telephone
Y
T
OUR
ELEPHONE
You can use a headset that has a microphone with any telephone on an
NBX system.
For how to use a typical headset and amplifier with telephones other
■
than the 3102 Business Telephone, see
Instructions"
later in this section.
For how to connect and use a headset with the 3102 Business
■
Telephone, read the next section.
The NBX 3102 Business Telephone has a headset jack located on the
underside of the telephone on the left side.
To prepare the headset for all calls on the 3102 Business Telephone:
1 Plug the headset connector into the headset jack on the underside of the
telephone. See
Figure 1
2 Press the Headset button. By default, this button is the Access button
just below the
telephone.
3 Verify that the indicator light beside the Headset button turns on.
To answer a call when you are using the headset:
1 Put the headset on. When a call comes in, press the System Appearance
button beside the flashing light. You are connected to the call.
The handset can be either on hook or off hook.
2 To end a call when you are using the headset, press the Release button
on the telephone. By default, the Release button is located at the
bottom of the right column of Access buttons.
in
Chapter 2
for the location of the jack.
(Program) button at the top right corner of the
"General Headset
Advertisement
Table of Contents
