Table of Contents
Advertisement
48
C
6: NBX M
HAPTER
Creating and
Sending a Message
ESSAGING
To create and send a message directly without actually making a call,
follow these steps:
1 Log in to your mailbox at your telephone or remotely.
2 Dial 2 to select Create and Send a Message.
3 At the tone, record a message that is at least 2 seconds long, and press #
to end the recording.
4 Optionally, press one of these buttons, OR proceed to step 5.
Re-record the message.
Review the message.
Mark the message Private or Urgent. See
Message as Private or Urgent"
Cancel the message.
5 When you are ready to send the message, press 1.
6 Dial one of these destination numbers plus #:
The internal extension or mailbox number of the recipient
■
A One-Touch (not available on NBX Basic Telephones), personal, or
■
system-wide speed dial number. See
A personal voice mail group list number. (See
■
Mail Group Lists"
A site code plus extension (to send to a user on another NBX system in
■
your organization). Example: neee or neeee (where n = one or more
site code digits and e = the extension digits on the other system)
For valid site codes in your organization, see your administrator.
7 To send the message to several recipients, dial each destination number
followed by #.
8 After the last destination number and its #, press #. Your message is sent.
later in this chapter.
"Speed Dials"
later in this chapter.)
"Marking a
in
Chapter
8.
"Creating Personal Voice
Advertisement
Table of Contents
