Table of Contents
Advertisement
ICMP
7.10 ICMP HDD status LEDs
ICMP HDD status LEDs
Image 7-11
4
HDD I/O LED
5
RAID LED
Status overview HDD I/Oand RAID LEDs:
HDD I/O
Off
Blinking Green
Blinking Green
Blinking Red
Off
Troubleshooting
Situation
One disk failed (red LED) + RAID degraded.
The ongoing event is not interrupted.
Note: The disk status (RAID degraded) can be
retrieved via the (Web) Commander. See user guide
of the (Web) Commander.
One disk failed (red LED) + Error 10580 "local
storage not available".
Note: The disk status (Error code) can be retrieved
via the (Web) Commander. See user guide of the
(Web) Commander.
114
R5905754 /13
DPxK-32B
ICMP HDD Status
RAID
Off
HDD idle / Disk in RAID OK.
Off
HDD I/O activity / Disk in RAID OK.
HDD I/O activity / RAID rebuilding.
Red
HDD idle / Disk error. See troubleshooting table below for curative actions.
Solution
1.
Switch off the power.
2.
Replace the defect HDD with approved model of
the same storage capacity. See procedure
"Removing a HDD from the ICMP", page 120,
and "Installing a HDD into the ICMP", page 121.
Ensure to insert the HDD firmly.
3.
Switch on the power.
Result: As soon the new HDD is detected by the
ICMP the rebuild of the RAID is started (Blinking red
LED).
1.
Switch off the power.
2.
Replace the defect HDD with approved model of
the same storage capacity. See procedure
"Removing a HDD from the ICMP", page 120,
and "Installing a HDD into the ICMP", page 121.
Ensure to insert the HDD firmly.
3.
Switch on the power.
Result: As soon the new HDD is detected by the
ICMP the rebuild of the RAID is started (Blinking red
LED).
Advertisement
Table of Contents
