Commissioning and Diagnostics
5.1
Configuring ET 200X-DESINA
Introduction
An ET 200X-DESINA channel assumes the functionality determined by the
settings sent to it on parameterization.
The possibilities are:
S Digital input
S Digital output
S Diagnostic input
S Diagnostics input with diagnostics frame
S Input with NC function
Parameterization for the functional input (Pin 2) is displayed and analyzed in
accordance with Table5-1.
Table 5-1
Pin 2 is "1" (+24 V)
Process image is always "0"
Diagnostics input (default)
Diagnostics input with diagnostics
frame
Input with NC function
Pin 2 is "0"
Process image is always "1"
Diagnostics input (default)
Diagnostics input with diagnostics
frame
Input with NC function
5-2
pin 4
Display and analysis of the parameters for the DESINA functional input
pin 2
LEDs
Redåoff
Process image
Redåoff
Process image and
SFC 13, for example
(see Section 5.6.1)
Yellowåon
Process image
LEDs
Redåon
Process image
Redåon
Process image and
SFC 13, for example
(see Section 5.6.1)
Yellowåoff
Process image
ET 200X Distributed I/O Device
EWA 4NEB 780601602-06
Analysis
Analysis