Blaupunkt BREMEN RCM 127 Operating Instructions Manual page 36

Fast forward or reverse in a message:
Press and hold down CUE or
message as it is fast forwarded or reversed.
End playback:
Playback will stop automatically after T1 has been played.
You can end the playback immediately by
pressing TIM, EXIT
•
TIM standby mode while the radio is switched off
The TIM standby mode is active if the display shows TIM ACTIVE after the
radio has been switched off.
In this case the radio will record all traffic bulletins broadcast by the tuned in
station for three hours after the set has been switched off.
During this period a motor antenna will remain fully extended.
The set will also record the traffic information broadcast for 90 minutes before
and after the programmed TIM times. During these periods a motor antenna will
also remain out.
Switching the TIM standby mode on/off
Automatically:
The TIM standby mode will switch off automatically if the car radio is not turned
on within 72 hours.
Switching the set back on re-activates the standby function.
REVIEW and you will be able to hear the
or SRC on the remote control.
S
TIM ACTIVE
S
TIMER 1
- HOURS HOURS +
- MIN
TIMER 1 TIMER 2
ACTIVE
07:00
MIN +
EXIT
36