Blaupunkt BREMEN RCM 127 Operating Instructions Manual page 34

Using the DSC MAIN MENU
Press S for approximately 1 second. DSC-MAIN MENU will appear in the
•
display header.
VARIOUS,
• Press
Programming the TIM standby mode / TIM times
You can programme two TIM times (TIMER 1 and TIMER 2).
For example, TIMER 1 could be for the time that you leave home in the morning,
TIMER 2 for the time that you drive home after work.
The TIM times to be programmed should correspond to the approximate times of
departure. The radio will then record the traffic information broadcast for 90 min-
utes before - and after - this time, i.e. lasting a total of three hours.
Attention: During this period, a motor antenna will remain fully extended. Be
sure to read the important warning note at the end of this section.
programmed
start TIM-TIME
1.5 hours
The motor antenna
will remain fully extended.
Calling up the TIM menu:
• Press TIM for approximately 1 second. The TIM menu will appear in the
display. You can set the TIM times.
CLOCK one after the other and set the correct time.
end
1.5 hours
S
TIMER 1
- HOURS HOURS +
- MIN
TIMER 1 TIMER 2
ACTIVE
07:00
MIN +
EXIT
34