Blaupunkt BREMEN RCM 127 Operating Instructions Manual page 19

Note:
If a station is displayed but crossed out in the preference menu, this means that
either the reception is very poor or that the station could not be clearly identified
as the one stored.
Stations on the same frequency which do not transmit an RDS signal cannot be
clearly differentiated from one another.
. . . by station search or manually
You must select the station search menu first.
You can switch from the reception or preference table
• by pressing SEARCH.
The search menu has been selected when SCAN appears in the upper left cor-
ner of the display.
Start the station search function by pressing
• (up) or (down).
The station search will stop at the next station within reception range.
The station search sensitivity selected LOCAL or DX (distant) will be highlighted
in the display.
• You can toggle between the two levels of station search sensitivity by
pressing the corresponding softkey
The station search sensitivity can be set separately for LOCAL and DX. For more
information refer to the section on "Programming with DSC – TUNER, S-LO or
S-DX".
If you hold down / , the station search will run forwards or backwards quickly.
Start the manual station search by pressing << or >>, the frequency will move
up or down in increments.
If you hold << or >> down, then the frequencies will run through quickly.
DEUTSCH ENGLISH
.
FRANÇAIS ITALIANO
S
SEARCH
SCAN
D-Radio
BREMEN 1
BREMEN 2
S
SCAN
LOCAL
DX
STORE
NEDERLANDS SVENSKA
NDR 2
BREMEN 3
HR 3
NDR1 NDS
NDR 2
NDR 3
NDR 2 92.10
EXIT
ESPAÑOL
CD - Betrieb (Option)
19
PORTUGUÊS