Changing The Positions That Signals Are Sent To The Aux 1 Bus From Each Channel; Setting The Solo Function For All Channels - Tascam 12 Owner's Manual

9 - Other functions
Changing the positions that signals are
sent to the AUX 1 bus from each channel
The positions from which signals are sent from the channels to
the AUX 1 bus can be changed.
This setting is shared by channels 1–6, 7/8 and 9/10.
1.
When the recorder is stopped, select MIXER on the MENU
Screen, and open the MIXER Screen. (see "Menu operation
procedures" on page 21)
2.
Select AUX1 SEND on the MIXER Screen, and open the
AUX1 SEND Screen.
3.
Turn the MULTI JOG dial to select the signal sent to the
AUX 1 bus.
Option Meaning
PRE FADER The signal is sent to the AUX 1 bus before
(default) adjustment by the channel fader.
The signal is sent to the AUX 1 bus after
POST FADER
adjustment by the channel fader.
4.
Press the MULTI JOG dial to confirm the setting.
The MIXER Screen reopens.
46
TASCAM Model 12

Setting the solo function for all channels

This sets the function of the SOLO buttons.
This setting is shared by channels 1–6, 7/8 and 9/10.
1.
When the recorder is stopped, select MIXER on the MENU
Screen, and open the MIXER Screen. (see "Menu operation
procedures" on page 21)
2.
Select SOLO MODE on the MIXER Screen, and open the
SOLO MODE Screen.
3.
Turn the MULTI JOG dial to select the solo mode.
Option Meaning
Pressing the SOLO button sends the
PFL (default)
channel signal to the SOLO L/R bus.
Pressing the SOLO button mutes the
INPLACE SOLO
signals of other channels.
4.
Press the MULTI JOG dial to confirm the setting.
The MIXER Screen reopens.