Mixer Functions; Selecting The Positions That Recording Signals Are Sent From Each Channel; Setting The Phase Of Each Channel - Tascam 12 Owner's Manual

Mixer functions

Selecting the positions that recording
signals are sent from each channel
The signals that are sent from each channel for recording to an
SD card can be set to before or after the compressor or after the
equalizer.
1.
When the recorder is stopped, select MIXER on the MENU
Screen, and open the MIXER Screen. (see "Menu operation
procedures" on page 21)
2.
Select MTR/USB SEND POINT on the MIXER Screen, and
open the MTR/USB SEND POINT Screen.
NOTE
Press the F4
button to change the settings for all
channels at the same time.
3.
Select the channel to be changed, and press the MULTI JOG
dial.
This opens the setting screen for the selected channel.
4.
Turn the MULTI JOG dial to select the send position.
Option Meaning
PRE COMP The signal of the channel is recorded to
(default) the SD card before the compressor.
The signal of the channel is recorded to
POST COMP
the SD card after the compressor.
The signal of the channel is recorded to
POST EQ
the SD card after the equalizer.
5.
Press the MULTI JOG dial to confirm the setting.
The MTR/USB SEND POINT Screen reopens.
9 - Other functions

Setting the phase of each channel

The phase of each channel can be set.
1.
When the recorder is stopped, select MIXER on the MENU
Screen, and open the MIXER Screen. (see "Menu operation
procedures" on page 21)
2.
Select PHASE on the MIXER Screen, and open the PHASE
Screen.
3.
Select the channel with the signal phase to change, and
open its settings screen.
4.
Turn the MULTI JOG dial to change the signal phase.
Option Meaning
NORMAL (default) Normal phase
INVERT Inverted phase
5.
Press the MULTI JOG dial to confirm the setting.
The PHASE Screen reopens.
45
TASCAM Model 12