Undoing Operations; Undoing The Previous Operation; Using The Built-In Effects; Setting The Built-In Effect - Tascam 12 Owner's Manual

Undoing operations

If you make a mistake operating the unit or want to do a
recording over, for example,the operation last conducted can be
undone. Editing, recording and other operations can be undone.
The following types of operations can be undone.
o Recording operations
o Auto punch in/out operations
o Track clearing operations
If a song is loaded or the unit is turned off, Information used
for undoing and redoing will be lost, so undoing and redoing
previous operations will no longer be possible.
NOTE
Files used for undoing are temporarily saved on the SD card.
If you want to delete those files to make more space on the
SD card, reload the current song on the SONG Screen.

Undoing the previous operation

When the Home Screen is open, press the F3
1.
The following confirmation pop-up message will appear.
Press the F4
2.
button to return to the state before the
previous operation.
NOTE
To cancel undoing, press the F1
Redoing an undone operation
1.
After undoing, when the "
Screen, press the F3
The following confirmation pop-up message will appear.
Press the F4
2.
button to restore the previous operation
and return to the state before undoing.
NOTE
To cancel redoing, press the F1
button.
button.
" appears on the Home
button.
button.
5 - Basic recording

Using the built-in effects

This unit has built in effects, so you can apply effects without an
external effect device.
Channels 1-6 and 7/8-9/10 can have an effect applied. Their
signals are sent to the built-in effect by the AUX2/FX bus.
The return signal is sent to the following buses.
i MAIN MIX L/R bus
i SOLO L/R bus
i AUX1 bus
i SUB L/R bus
ATTENTION
When the AUX OUTPUT AUX 2 jack is in use,
on the Home Screen and the built-in effects cannot be used.
1.
Use the AUX 2/FX knobs of each channel to adjust the levels
of signals sent to the AUX2/FX bus.
2.
Use the EFFECT Screen to select the type of effect. (see
"Setting the built-in effect" on page 33)
3.
Use the FX fader and TO AUX 1 knob to adjust the return
levels for each bus.

Setting the built-in effect

1.
Press the SELECT button to open the EFFECT Screen.
2.
Turn the MULTI JOG dial, and set the built in effect type.
Options: 1.HALL1 (default), 2.HALL2,
3.ROOM1, 4.ROOM2,
5.PLATE, 6.STUDIO,
7.LIVE, 8.DELAY1,
9.DELAY2, 10.PING PONG,
11.CHORUS, 12.FLANGER,
13.DELAY+HALL1, 14.DELAY+HALL2,
15.CHORUS+HALL1, 16.CHORUS+HALL2
3.
Press the MULTI JOG dial to select the PARAMETER item.
The parameter item is dependent on the selected effect.
appears
33
TASCAM Model 12