Install A Hot-Swap Power Supply; Static Sensitive Device Ground Package Before Opening - Lenovo ThinkSystem SR650 Series Setup Manual

Table 31. PCIe switch adapters and the corresponding PCIe slots
Type of PCIe switch adapter
810-4P NVMe switch adapter (with the 3U bracket
installed)
810-4P NVMe switch adapter (with the 2U bracket
installed)
810-4P NVMe switch adapter (with the 3U bracket
installed)
810-4P NVMe switch adapter
1610-8P NVMe switch adapter
Watch the procedure. A video of the installation process is available:
• Youtube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-A25P7vBoGa_wn7D7XTgDS_
• Youku:
http://list.youku.com/albumlist/show/id_50483444
Step 1. Install the three 2.5-inch NVMe 8-Bay backplanes. See
apply drive bay sequence labels above the drive bays on your server.
Step 2. Install three brackets on three 810-4P NVMe switch adapters. To install the bracket, align the screw
holes in the bracket with the corresponding holes in the switch adapter, and then, install the screws
to secure the bracket to the switch adapter.
Step 3. Install the 810-4P NVMe switch adapter in the RAID adapter slot on the system board. See
the RAID adapter
Step 4. Install the 810-4P NVMe switch adapter with 2U bracket in PCIe slot 4 on the system board. See
Install a PCIe adapter on the system board
Step 5. Install the riser card 1 on riser 1 bracket. See
Step 6. Install the 1610-8P NVMe switch adapter in PCIe slot 1 on riser card 1. Then, install the 810-4P
NVMe switch adapter with 3U bracket in PCIe slot 2 on riser card 1. See
.
riser assembly
Step 7. Install the riser 1 assembly to the chassis. See
Step 8. Install the riser card 2 on riser 2 bracket. See
Step 9. Install the 810-4P NVMe switch adapter with 3U bracket in PCIe slot 6 on riser card 2. See
PCIe adapter on the riser assembly
Step 10. Install the riser 2 assembly to the chassis. See
Step 11. Install any required hardware or server options, and then cable the server. To connect the cable for
server models with twenty-four NVMe drives, see "Server model: twenty-four 2.5-inch NVMe
drives, four NVMe 810-4P switch adapters, one NVMe 1610-8P switch adapter" in the topic
models with twenty-four 2.5-inch drives

Install a hot-swap power supply

Use this information to install a hot-swap power supply.
"Read the
installation
Guidelines" on
page 126
.
.
.
Ground package before opening"
PCIe slot selection
Slot 2 on riser card 1
Slot 4 on the system board
Slot 6 on riser card 2
RAID adapter slot on the system board
Slot 1 on riser card 1
Install the 2.5-inch-drive backplane
.
.
Install a riser card
.
Install a riser card
.
Install a riser card
Install a riser card .
"ATTENTION:
Static Sensitive Device
on page 127
. Then,
Install a PCIe adapter on the
.
Chapter 3 Server hardware setup
Install
Install a
Server
181