Install The Rear Hot-Swap Drive Assembly - Lenovo ThinkSystem SR650 Series Setup Manual

The following illustration shows the location for applying the drive bay label to the server models
with a 12-bay backplane installed. The location is the same for applying the drive bay label to
server models with an 8-bay backplane or an AnyBay 12-bay backplane installed. Ensure that the
drive bay label is stuck in the correct location. The label helps you to locate the correct drive during
problem determination.
Figure 85. Drive bay label for server models with a 12-bay backplane installed
After installing the 3.5-inch-drive backplane, connect the cables to the system board. For information about
the cable routing, see "Internal cable routing" on page 35.

Install the rear hot-swap drive assembly

Use this information to install the rear hot-swap drive assembly. This topic applies only to server models that
support the rear hot-swap drive assembly.
"Read the
installation
Guidelines" on
page 126
Before installing the rear hot-swap drive assembly, touch the static-protective package that contains the new
rear hot-swap drive assembly to any unpainted surface on the outside of the server. Then, take the new rear
hot-swap drive assembly out of the package and place it on a static-protective surface.
To install the rear hot-swap drive assembly, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-A25P7vBoGa_wn7D7XTgDS_
• Youku: http://list.youku.com/albumlist/show/id_50483444
158
ThinkSystem SR650 Setup Guide
"Power off
the server for
this task" on
page 194
"ATTENTION:
Static Sensitive Device
Ground package before opening"
on page 127