Install The Lom Adapter - Lenovo ThinkSystem SR650 Series Setup Manual

Before installing the PCIe adapter on the system board:
1. Touch the static-protective package that contains the new PCIe adapter to any unpainted surface on the
outside of the server. Then, take the new PCIe adapter out of the package and place it on a static-
protective surface.
2. If the new PCIe adapter is installed with a full-height bracket, replace the full-height bracket with the low-
profile bracket by doing the following:
a. Carefully remove the screws that secure the PCIe adapter and then remove the full-height bracket
from the PCIe adapter.
b. Note the orientation and align the screw holes in the low-profile bracket with the corresponding holes
in the PCIe adapter. Then, install the screws to secure the bracket to the PCIe adapter.
To install a PCIe adapter on the system board, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-A25P7vBoGa_wn7D7XTgDS_
• Youku:
http://list.youku.com/albumlist/show/id_50483444
Step 1. Position the PCIe adapter near the PCIe slot. Then, carefully press the PCIe adapter straight into
the slot until it is securely seated and its bracket also is secured by the chassis.
Figure 103. Installing a PCIe adapter on the system board
Step 2. Pivot the PCIe adapter retention latch to the closed position to secure the PCIe adapter in position.
After installing the PCIe adapter on the system board, connect cables to the PCIe adapter.

Install the LOM adapter

Use this information to install the LOM adapter.
174
ThinkSystem SR650 Setup Guide