Table of Contents
Advertisement
13. The lamp becomes extremely hot during the operation. Allow the projector to
cool for approximately 45 minutes prior to removing the lamp assembly for
replacement. Do not operate lamps beyond the rated lamp life. Excessive
operation of lamps beyond the rated life could cause them to explode on rare
occasions.
14. Never replace lamp assembly or any electronic components unless the projector
is unplugged.
15. Always open the lens shutter or remove the lens cap when the projector lamp
is on.
16. In some countries, the line voltage is NOT stable. This projector is designed to
operate safely within a bandwidth of 110 to 230 volts, but could fail if power
cuts or surges of +/-10 volts occur. In these high-risk areas, it is recommended
to install a power stabilizer unit.
17. Do not point the laser pointer directly to the people's eyes (especially small children).
There is a danger of injury to the eyes. So keep the Remote Control out of the
reach of children.
Projector
3
Advertisement
Table of Contents
