Protecting The Environment - DeWalt DW099 Instructions Manual

• Measure the vertical difference between the
markings (14 & 17).
• If the difference between the markings is 4 mm
or less, the tool is properly calibrated.
• If the difference between the markings is more
than 4 mm, the tool must be serviced.
Square angle check (fig. H1 - H3)
• Place the tool in an area of at least 10 m by 5 m.
Position the tool so that it is aimed front-to-back
towards the short walls.
• Place the tool at approximately 10 cm from the
wall as measured from the front of the tool.
Level the tool as required. Mark the centre of the
up laser aperture (18) on the floor.
• Switch on the tool. Mark the centre of the front
laser dot (19) on the opposite short wall.
• Locate the position of the front laser beam
halfway between the short walls using a target.
Mark this point (20) on the floor. Switch off the
tool.
• Move the tool in a straight line to the floor
marking (20).
• Align the up laser aperture with the floor marking
(20). Level the tool as required.
• Switch on the tool. Align the front laser beam
with the wall marking (19).
• Mark the centre of the square laser dot (21) on
the long wall.
• Switch off the tool and rotate it 90° clockwise.
• Align the up laser aperture with the floor marking
(20). Level the tool as required.
• Switch on the tool. Align the front laser beam
with the wall marking (21).
• Locate the position of the square laser beam
parallel to the starting point (18) at the short wall
using a target. Mark this point (22) on the floor.
Switch off the tool.
• Measure the difference between the markings
(18 & 22).
• If the difference between the markings is 9 mm
or less, the tool is properly calibrated.
• If the difference between the markings is more
than 9 mm, the tool must be serviced.
Cleaning
• Remove the batteries before cleaning the tool.
• Regularly clean the housing with a soft cloth.

Protecting the environment

Separate collection. This product must
not be disposed of with normal
household waste.
Should you find one day that your D
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make this
product available for separate collection.
Separate collection of used products
and packaging allows materials to be
recycled and used again. Re-use of
recycled materials helps prevent
environmental pollution and reduces the
demand for raw materials.
Local regulations may provide for separate collection
of electrical products from the household,
at municipal waste sites or by the retailer when you
purchase a new product.
D WALT provides a facility for the collection and
E
recycling of D WALT products once they have reached
E
the end of their working life. To take advantage of this
service please return your product to any authorised
repair agent who will collect them on our behalf.
You can check the location of your nearest authorised
repair agent by contacting your local D
at the address indicated in this manual. Alternatively,
a list of authorised D WALT repair agents and full
E
details of our after-sales service and contacts are
available on the Internet at: www.2helpU.com
Batteries
• When disposing batteries, think of the protection
of the environment. Check with your local
authorities for an environmentally safe way of
battery disposal.
E N G L I S H
WALT product
E
WALT office
E
25