DeWalt DW099 Instructions Manual page 22

E N G L I S H
Safety instructions
When using power tools, always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and
personal injury.
Read all of this manual carefully before operating
the tool. Also refer to the manual of any power
tool that will be used with this tool.
Save this manual for future reference.
General
1 Keep work area clean
Cluttered areas and benches can cause accidents.
2 Consider work area environment
Do not expose power tools to humidity.
Keep work area well lit. Do not use power tools
in the presence of flammable liquids or gases.
3 Guard against electric shock
Prevent body contact with earthed surfaces
(e.g. pipes, radiators, cookers and refrigerators).
For use under extreme conditions (e.g. high
humidity, when metal swarf is being produced,
etc.) electric safety can be improved by inserting
an isolating transformer or a (FI) earth-leakage
circuit-breaker.
4 Keep children away
Do not let children come into contact with the
tool or extension cord. Supervision is required for
those under 16 years of age.
5 Use appropriate tool
The intended use is described in this instruction
manual. Do not force small tools or attachments
to do the job of a heavy-duty tool. The tool will
do the job better and safer at the rate for which it
was intended.
Warning! The use of any accessory or attachment
or performance of any operation with this tool,
other than those recommended in this instruction
manual may present a risk of personal injury.
6 Maintain tools with care
Keep the tools in good condition and clean for
better and safer performance. Follow the
instructions for maintenance and changing
accessories. Inspect the tool cords at regular
intervals and, if damaged, have them repaired by
an authorized D WALT repair agent. Keep all
E
controls dry, clean and free from oil and grease.
22
7 Store idle tools
When not in use, power tools must be stored in
a dry place and locked up securely, out of reach
of children.
8 Check for damaged parts
Before using the tool, carefully check it for damage
to ensure that it will operate properly and perform
its intended function. Check for misalignment
and seizure of moving parts, breakage of parts
and any other conditions that may affect its
operation. Have damaged guards or other
defective parts repaired or replaced as instructed.
Do not use the tool if the switch is defective.
Have the switch replaced by an authorized
D WALT repair agent.
E
9 Remove the batteries
Remove the batteries when not in use,
before servicing and when changing accessories.
10 Have your tool repaired by an authorized
D WALT repair agent
E
This power tool is in accordance with the relevant
safety regulations. To avoid danger, electric
appliances must only be repaired by qualified
technicians.
Additional safety instructions for batteries
• Do not attempt to recharge batteries.
• Do not open or mutilate batteries for any reason.
• Do not expose batteries to water.
• Do not expose batteries to fire.
• Do not attempt to recharge batteries.
• Do not store batteries in locations where the
temperature may exceed 40 °C.
• Use only the correct size of batteries. When
replacing, do not mix old batteries with new ones.
• Under extreme conditions, battery leakage may
occur. When you notice liquid leaking out,
proceed as follows:
- Carefully wipe the liquid off using a cloth.
Avoid skin or eye contact. Do not swallow.
- In case of skin or eye contact, rinse the liquid
off with clean flowing water for at least
10 minutes and contact a doctor.
Fire hazard! Avoid short-circuiting the
contacts of a removed battery.