LTPH-UM-1109-01, Issue 1
Press this
To access this
key:
menu:
R
Rlogon/Rlogout
H
Help
P
T
ROVISIONING
After H2TU-C-231 is successfully installed, perform these basic provisioning tasks.
•
Set date and time (see
•
Set circuit ID numbers (see
•
Make any necessary configuration changes (see
•
Clear history, alarm, and event log screens to remove miscellaneous data during startup (see
History, Alarm, and Event Log Screens" on page
Setting Date and Time
Monitor
Performance
ID: xxxx--xxxx—-xxxx--xxxx
1
Press
C
to select the Config menu.
2
Use the
and
3
Type the date in the format indicated, then press
H2TU-C-231 List 2
Table 4.
Logon Screen Menus (Continued)
Menu Functions
Remote logon can be performed from the H2TU-C or H2TU-R. The screen displays "Rlogout"
when the H2TU-C or H2TU-R is remotely logged on to the other unit at the end of the circuit.
Remote logon from the H2TU-C will permit viewing of the H2TU-R and BERT Signal
Generator configuration submenu.
To log off from the remote unit, press
locally logged on until
Provides a glossary of terms used in the maintenance screens, a list of navigational keys, and
ADC contact information.
ASKS
"Setting Date and Time"
"Setting Circuit ID Numbers" on page
Event Log
Config
+----------------------+
| Standard Options ->
| ADC Options
| BERT Generator
|
Date and Time
+-------------------------------+
| Date (mm/dd/yyyy): 05/15/2001|
| Time (hh:mm[:ss]): 12:30:01
+-------------------------------+
09/01/2001 12:30:01
Figure 4. Config Menu - Date and Time
arrow keys to select Date and Time, then press
January 9, 2002
R
. "Rlogout" changes to "Rlogon". The unit is now
R
is pressed again to re-initiate the remote logon.
below)
14)
"Configuring the System" on page
23)
Inventory
Report
|
->
|
->
|
->
|
H2TU-C
ENTER
ENTER
.
Provisioning
15)
"Clearing the
Rlogon
Help
|
System:
OK___
.
13