Maintenance And Troubleshooting - Pro-Form CARBON E7 User Manual

MAINTENANCE AND TROUBLESHOOTING

MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the elliptical is used.
Replace any worn parts immediately.
To clean the elliptical, use a damp cloth and a small
amount of mild soap. IMPORTANT: To avoid damage
to the console, keep liquids away from the console
and keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power cord is fully plugged in and that the power
switch is in the reset position.
If the console does not display your heart rate when
you hold the handgrip heart rate monitor, or if the
displayed heart rate appears to be too high or too low,
see step 5 on page 23.
If the console does not boot up properly, or if the con-
sole freezes and does not respond, reset the console
to the factory default set-
tings. IMPORTANT: Doing
this will erase all custom
settings you have made
to the console. Resetting
the console requires two
people. First, press the power switch into the off posi-
tion. Next, locate the small reset opening (A) on the
back or the side of the console. Using a bent paper
clip, press and hold the reset button inside the open-
ing, and have a second person press the power switch
into the on position. Continue holding the reset button
until the console turns on. When the reset operation is
complete, the console will turn off and then turn back
on. If it does not, press the power switch off and then
on again. Once the console turns on, check for firm-
ware updates (see step 5 on page 28). Note: It may
take a few minutes for the console to be ready for use.
INCLINE SYSTEM TROUBLESHOOTING
If the ramp does not adjust to the selected incline level,
see step 6 on page 28 and calibrate the incline
system.
32
A