Kit Assembly - Metra Electronics 99-7314 Installation Instructions Manual

DIN radio provision with pocket
1. Remove the metal DIN sleeve from
the aftermarket radio.
2. Slide the sleeve into the radio
housing and secure by bending the
metal locking tabs down. (Figure A)
3. Slide the radio back into the sleeve
until it clicks in. (Figure A)
4. Locate the factory wiring harness
and antenna connector in the
dash. Metra recommends using
the proper mating adapter from
Metra or AXXESS. Re-connect the
negative battery terminal and test
the radio for proper operation.
5. Reassemble the dash in reverse
order of disassembly.

Kit Assembly

(Figure A)
99-7314
3