Dp750 Association With Dp760 Dect Repeater; Enabling Repeater Mode On Dp750; Dp760 Dect Repeater Association; Figure 35: Enable Repeater Mode - Grandstream Networks DP750 Administration Manual

DP750 ASSOCIATION WITH DP760 DECT REPEATER

Important Notes:
DP760 can relay up to 2 concurrent calls.
-
After pressing Page/Reset button for more than 2 seconds on the DP760, it will enter AUTO region
-
mode, in this mode, the three LEDs of right side keep quick blinking, then the DP760 will search
the base signal in the current environment to auto associate with it and then auto switch to the
same region (EU, US or BR) of the base station.
If you have a DP760 that has FW before 1.0.3.34, you will need upgrade it to 1.0.3.34 first, then do
-
a factory reset. After that, the unit will support Auto-Region feature and it will enter Auto Region
mode.

Enabling Repeater Mode on DP750

Before associating the DP760 DECT Repeater to your DP750 Base Station, you should firstly enable the
repeater mode on your base station. Please refer following steps to enable the repeater mode on the DP750
base station:
1. Access the Web GUI of your DP750 using the admin's username and password. (Default username
and password are: admin/admin).
2. Navigate to DECT  General Settings and set Enable Repeater Mode to Yes.
3. Press Save and Apply, then Reboot the base to apply the new settings.

DP760 DECT Repeater Association

After enabling the repeater mode on DP750 Base Station, you can easily associate it with your DP760
DECT Repeater using one of the following methods:

Auto Association
Figure 36: Enable Repeater Mode
DP750/DP720 Administration Guide
Version 1.0.11.4
P a g e | 95