Configuration Options; Programming With The Service Device Tcsk-01; General Information On The Conduit In Tcs Audio Systems - TCS ISW3030 Product Information

function
ring tone volume
voice volume
selecting ring tones for door calls,
internal calls and floor calls
ring tone for door call 2
parallel allocation
change audio AS border
block ring tone output
block ring tone selection
reset to factory settings

Programming with the Service Device TCSK-01

 The indoor station is acting like a device for manually controlled duplex communication.
 Use the commands „8" for configuring (see product information Service Device TCSK-
01).
Ser. no. = the serial number of the new indoor station that should be configured
ParSNo. = the serial number of the indoor station, to which the new configured indoor station is allocated

General information on the conduit in TCS audio systems

The conduit is determined by structural conditions and is only limited by its length
.
 Note when choosing the cables: the loop re-
sistance can amount max. 20 Ω (table)
 In compliance to the max. permitted loop re-
sistance the wire cross-section can be doubled,
that means, that for one wire two lines can be
used (illustration). The lines have to be twisted.
 In case of using shielded cables: connect the
shielding with each other and put i tone-sided on
mass (b-wire) in the power supply
 Optional strand or star formed wiring
TCS TürControlSysteme AG, TCS Hotline Germany: +49 (0) 41 94/ 9 88 11 88
Mail: hotline@tcsag.de
12

Configuration options

manually
x
x
x
–
–
–
x
–
configo
TCSK-01
from version 1.3.3
–
–
–
–
x
–
–
–
Subject to technical changes.
ISW3030-0140 UK 2 A
07/2015
TM
-
-
x
x
x
x
–
x
x