Advertisement
(4) Loosen the two screws that hold the punch unit
in place.
(5) Using the triangle marks on the plate as a guide,
move the punch unit back and forth to adjust its
position.
(6) After the adjustment, tighten the two screws
loosened in step (4).
(7) Close the upper cover of the finisher.
(8) Make a copy and check the punch hole positions
again.
<Punch hole position adjustment>
Note:
Perform this adjustment if necessary.
(1) Make a copy in the punch mode.
(Refer to the User's Guide CD)
(2) Measure width A on the copy and check to see if
the measured dimension falls within the speci-
fied range.
<North America: 2 holes, 3 holes>
Specifications: 9.5 ± 1.0 mm
<Europe: 4 holes>
Specifications: 11 ± 1.0 mm
<Sweden: 4 holes>
Specifications: 10.5 ± 1.0 mm
Note:
If the measured width A outside the specified
range, perform the following procedure to punch
hole position adjustment.
<North America:
2 holes>
A
<Europe: 4 holes>
A
(3) Display the Service Mode screen.
(For details of how to display the Service Mode
screen, see the service manual.)
(4) Touch "Finisher."
(5) Touch "FS-FN adjustment."
(6) Touch "Punch Edge Adj."
(7) Set the correction value using the
keys.
• To make width A wider, enter a positive value.
• To make width A narrower, enter a negative
value.
E-4
<North America:
3 holes>
A
<Sweden: 4 holes>
A
/
Advertisement
