Table of Contents
Advertisement
im Vertrieb von
Setup (Configuration) Procedure
Normal Mode
DISPLAY
ROOM
POWER
MUTE
Press and hold all 3 DISPLAY buttons
together for 2 seconds.
Press and hold
all 3 DISPLAY buttons
together for 2 seconds
to return to Normal Mode.
or
Clearing button
Wait 20 seconds
configurations
for the System 5 to
time out to Normal Mode.
audio input
attenuation
Selecting
video formats
Initiating
IR learning
www.camboard.de
CAMBOARD Electronics
Setup
TX
MODE
(Config)
CONFIG
RETRY
Mode
CONFIG LED lights
Press the ROOM button twice.
The ROOM LED blinks for 8 seconds.
During that time, do one of the following:
ROOM
Press any desired front panel button to clear & reset only that button's IR configuration.
or
Press all 3 DISPLAY buttons at the same time for 2 seconds to clear and reset all System 5 settings.
With an active audio signal present,
press an input's button twice in quick succession
to adjust its audio input. The input's LED blinks.
Setting
PC1
PC2
INPUT3
PC
VID
Y/C
levels
Press and hold the ROOM button
while setting video formats.
ROOM
POWER
Press the
DISPLAY POWER,
CONFIG
MUTE, or MODE
RETRY
button & hold it
for 2 seconds.
CONFIG LED blinks
AUDIO
Tel. 07131 911201
Fax 07131 911203
At any point after entering
the setup mode, you can
Configure
any of the features described here,
in any order,
or
Wait 20 seconds to time out to Normal mode.
DISPLAY
POWER
MUTE
MODE
PC1
PC2
AUDIO
VID1
VID2
MAX.
VID
VID
CLIP
Y/C
Y/C
MIN.
VOLUME
Turn VOLUME knob up (clockwise)
Turn VOLUME knob
until CLIP LED is on or blinking fast.
down (counter-clockwise)
until the CLIP LED is off or
blinks occasionally as
the level peaks.
DISPLAY
MUTE
MODE
PC1
PC2
INPUT3
PC
VID
Y/C
Press INPUT3 to toggle between
video formats for that input (an LED
lights to indicate the selected format).
TX
Point the projector's IR remote
control at the System 5's
IR LEARN port and firmly press
the desired button on the remote.
SYSTEM 5
PLUS
PC1 INPUT
IR
COMPUTER
TX
RX LEARN
CONFIG
RETRY
1
2
3
4
5
6
7
8
9
0
ce-info@camboard.de
INPUT3
VID1
VID2
PC
VID
VID
VID
Y/C
Y/C
Y/C
Press the input's
button once to
save. Repeat for
each audio input.
VID1
VID2
Release
the ROOM
VID
VID
Y/C
Y/C
button
Repeat for VID1 and VID2
TX
CONFIG LED lights steadly while
CONFIG
TX & RETRY LEDs flash to indicate
RETRY
that the signal has been learned.
or
TX
For POWER button configuration,
CONFIG
if the TX LED is off and both the
RETRY
CONFIG and RETRY LEDs blink,
the System 5 is ready to
learn the power-off signal.
Press the System 5's POWER
button twice in quick succession,
then aim the remote and press the
IR remote's power button again.
or
TX
If the TX LED is off and the
CONFIG
RETRY LED blinks once, press the
RETRY
POWER, MUTE, or MODE button
and the IR remote's button again.
Repeat all steps for each
DISPLAY button to be learned.
Advertisement
Table of Contents
