Setting Up The System 5C C C C C R R R R R Plus; Clearing Configurations - Extron electronics System 5cr Plus User Manual

im Vertrieb von
Setup and Operation, cont'd

Setting Up the System 5c c c c c r r r r r Plus

The System 5cr Plus must be set up (configured) before it can control other
equipment. Setup can be done from the front panel, or from a computer using the
provided control software. Setup cannot be done via the IR 401 remote control or
the SCP 100P control pad.
Extron provides preset configurations in the form of projector driver files that can
be downloaded from diskette or the Extron website. See "Downloading and using
projector drivers" in chapter 4 for details. Projector drivers assign projector IR
commands to the System 5's front panel controls so that the display power, mute,
and mode functions can be used to control the projector.
Configuring the System 5c c c c c r r r r r Plus from the front panel
The System 5 must be in the setup (config) mode during setup. The Config LED
lights when the setup mode is on. The following configuration procedures can be
performed from within setup mode:
• clear an individual button's IR function configurations,
• clear all System 5 settings,
• set audio input attenuation levels,
• select video formats,
• initiate IR learning.
See the flowcharts in this section for the specific steps for setting up the System 5.

Clearing configurations

Clearing configuration settings resets them to factory defaults. To clear
configurations, see the flowchart below.
Normal Mode
Press and hold
all 3 DISPLAY buttons
together for 2 seconds
to return to Normal Mode.
Wait 20 seconds
for the System 5 to
time out to Normal Mode.
www.camboard.de
3-4 System 5c c c c c r r r r r Plus • Setup and Operation
CAMBOARD Electronics
When there has been no activity for at least 20 seconds, the System 5 times out
from the setup mode to the normal mode, and the Tx, Config, and Retry LEDs
will all flash for 5 seconds.
Setup
DISPLAY
ROOM
POWER MUTE MODE
(Config)
Mode
Press and hold all 3 DISPLAY buttons
together for 2 seconds.
Press the ROOM button twice.
The ROOM LED blinks for 8 seconds.
During that time, do one of the following:
or
ROOM
Press any desired front panel button to clear & reset only that button's IR configuration.
or
Press all 3 DISPLAY buttons at the same time for 2 seconds to
clear and reset all System 5 settings.
Pressing all three Display buttons clears and resets all configuration settings
to the factory defaults. These settings include Display functions, IR commands,
room settings, video type, RGB delay, power up/down delay, room relay mode,
audio gain, and all other settings.
Tel. 07131 911201
Fax 07131 911203
At any point after entering
the Setup mode, you can
TX
Configure any feature in any order,
CONFIG
RETRY
Wait 20 seconds to time out to Normal mode.
CONFIG LED lights
DISPLAY
POWER MUTE MODE PC1 PC2 INPUT3
PC
VID
Y/C
ce-info@camboard.de
or
VID1 VID2
VID VID
Y/C Y/C