Table of Contents
Advertisement
im Vertrieb von
Setup and Operation, cont'd
Initiating IR learning
The System 5 can "learn" control commands from projectors' remote controls.
IR learning is only necessary if there is no IR driver available for that projector or if
the driver is not complete.
The System 5cr Plus has two portholes on its front panel:
TX
CONFIG
RETRY
During IR learning you might need to hold the projector's IR remote control as near
to the System 5 as one-half inch and point the remote directly at the IR learning
(Learn) device. Blocking ambient light from the IR learning device, particularly
from flourescent lights, can also help.
Normal Mode
Press and hold
all 3 DISPLAY buttons
together for 2 seconds
to return to Normal Mode.
Wait 20 seconds
for the System 5 to
time out to Normal Mode.
www.camboard.de
3-6
System 5c c c c c r r r r r Plus • Setup and Operation
CAMBOARD Electronics
•
one for the IR receiver (Rx), which receives signals
SYSTEM 5
Plus
from the IR 401 remote; and
IR
•
one for the IR learning device (Learn), which receives
RX
LEARN
signals from a projector's remote control during
IR learning.
Once the System 5 has been programmed to control the projector, do not
perform the learned projector control functions from the projector or the
projector's remote control. The System 5 will not know that projector control
commands have been sent by an external device. For example, if a projector is
powered on via the System 5, and then the projector is manually turned off at
the projector's panel, the System 5 will not know the projector is off, and it will
continue to send video signals and commands to the projector.
Setup
DISPLAY
ROOM
POWER
MUTE
MODE
(Config)
Mode
Press and hold all 3 DISPLAY buttons
together for 2 seconds.
Press the
DISPLAY POWER,
MUTE, or MODE
button & hold it
for 2 seconds.
or
PC1 INPUT
AUDIO
COMPUTER
Tel. 07131 911201
Fax 07131 911203
At any point after entering
the Setup mode, you can
TX
Configure any feature in any order,
CONFIG
RETRY
Wait 20 seconds to time out to Normal mode.
CONFIG LED lights
TX
CONFIG
RETRY
CONFIG LED blinks
TX
CONFIG
RETRY
Point the projector's IR remote
control at the System 5's
IR LEARN port and firmly press
TX
the desired button on the remote.
CONFIG
RETRY
SYSTEM 5
PLUS
IR
TX
RX LEARN
CONFIG
RETRY
TX
CONFIG
RETRY
1
2
3
4
5
6
7
8
9
0
Repeat all steps for each
DISPLAY button to be learned.
ce-info@camboard.de
or
CONFIG LED lights steadly
while TX & RETRY LEDs flash to
indicate that the signal was learned.
or
For POWER button configuration,
if the TX LED is off and the
CONFIG and RETRY LEDs both
blink, the System 5 is ready to
learn the power-off signal.
Press the System 5's POWER
button twice in quick succession,
then aim the remote and press the
IR remote's power button again.
or
If the TX LED is off and the
RETRY LED blinks once, retry by
pressing the POWER, MUTE, or
MODE button and the IR remote's
button again.
Advertisement
Table of Contents
