USSC 6041 How To Use And Maintain page 9

Step Four: Vacuum Burn Chamber and Rear Vent Chamber
Action One: Use Ash-Vac to thoroughly vacuum burn chamber of all ash (Figure 10).
Action Two: Locate four entry points to the rear vent chamber, behind the burn chamber, as
indicated in Figure 11 where the yellow circles are. For the two lower entry points of the rear
vent chamber, lift and remove trapdoors.
Action Three: Use Ash-Vac, with small crevice tool, to vacuum rear vent chamber via the four
entry points. Figures 12 & 13 depict a clean rear vent.
Action Four: Replace the two trapdoors at the bottom of the rear vent chamber.
Figure 10
Figure 13
Action One: Replace vermiculite by carefully inserting it into catch bar and easing bottom
towards the back of burn chamber until it is properly seated.
Action Two: Replace burn pan and agitator by ensuring agitator is properly placed with two
prongs facing down and three up. Place right side of burn pan and agitator into slot and then
slide left side down until firmly seated.
Action three: Replace cotter pin to agitator
Action Four: Replace stove door if removed earlier.
Figure 11
Step Five: Replace Ash Pan and Vermiculite
Figure 12
9