USSC 6041 How To Use And Maintain page 24

Lesson Three – Maintain Consistent Heat: Check on Learning
Instructions: This end of lesson check on learning will consist of two parts. Part one is a written
exam to check your understanding of how to maintain a consistent heat level by adjusting the
various stove settings. Part two will be hands-on practice with a subject matter expert providing
over the shoulder assistance to ensure proper loading and startup of the stove.
–
Lesson Three Self-check
1. Where is the stove auger safety switch located in the pellet hopper?
2. Which picture shows the operator adjusting the pellet feed rate?
a.
3. Which picture shows the operator adjusting the agitator speed?
a.
4. When would you adjust the agitator to a level higher than the typical setting?
5. What adjustments would you make with the following situations?
a. Lazy Flame:
b. Flame With Too Much Air:
c. Smothered Flame:
d. Flame with Lack of Air:
6. State what type of flame the picture best depicts.
a. ______
d. ______
7. What two areas of the 6041 Multi-Fuel Stove will most likely cause poor airflow if filled with
excess ash?
b.
b.
b. ______
e. ______
c.
c.
c. _______
f. ______
24