Waveform Download and Fan RPM
Calibration
After replacing main board, fan, or upgrading the firmware, please do the following steps:
1.
Hold down the "power" button, then plug in the power cord.
2.
Release the power button when the power LED is flashing red.
3.
After several minutes, the projector will auto- power on, and the fan RPM calibration and
auto waveform is finished.
• If the factory fan value doesn't show in service mode, please repeat steps 1 to 2 again.
• Make sure the "Blower Factory RPM" is in the range from 2100 to 2600.
Waveform Download and Fan RPM Calibration
39