Furuno TZT12F Installation Manual page 54

3. HOW TO SET UP THE EQUIPMENT
Menu item
[Fish Finder Demo
Mode]
[Set Hardware to
Factory Default]
[Restore Default
Settings]
Transducer Setup menu
Note: When the DI-FFAMP is connected and [Transducer Setup Type] is set to [Man-
ual], the following message appears on the display. Contact your FURUNO dealer for
setup.
Menu item
[Transducer Setup
Type]
[Model Number]
[High Frequency Min]
[High Frequency Max] Display the high frequency maximum.*
[Low Frequency Min]
[Low Frequency Max]
[Reset Default Set-
tings]
*: This item is only available for DFF3 users.
When [Transducer Setup Type] is set to [Model] and connected to DFF3
Menu item
[High Frequency]
[Low Frequency]
3-18
Enable or disable the demonstration mode for the
sounder.
• [OFF]: Disable the demo mode.
• [Shallow]: Enable shallow water demo mode.
• [Deep]: Enable deep water demo mode.
Note: For internal fish finder and DI-FFAMP users, the set-
tings are as follows:
[Off], [Demo1] to [Demo4].
Reset the external fish finder to its factory default settings. [OK], [Cancel]
Restore all menu settings to default.
Select the type of transducer connected.
When the connected sounder is a DFF1-UHD and the
transducer has a compatible TDID, [TDID] is automati-
cally selected.
Note: When the transducer model is changed or TDID is
detected, the frequency and bandwidth set on [Manual] is
to be reset.
• [Manual]: Manually set up the transducer.
• [Model]: Select the appropriate transducer model
(for FURUNO or AIRMAR transducers).
Select the appropriate model number from the list.
Note: Only available when [Transducer Setup Type] is set to [Model].
Display the high frequency minimum.*
Display the low frequency minimum.*
Display the low frequency maximum.*
Reset the Transducer Setup menu settings to default.
Select the model and frequency (HF & LF) of the connected
transducer from the appropriate drop down menu.
Description
Description
Description
Options (setting
range)
[OFF], [Shallow],
[Deep]
[OK], [Cancel]
Options
(setting range)
[Manual],
[Model]
[OK], [Cancel]
Options
(setting range)