Lubrication; Greasing The Bearings And Bushings - Toro Reelmaster 5410 Operator's Manual

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Every 50 hours (and immediately
after every washing).
Lubricate all grease fittings for the bearings and
bushings after with No. 2 lithium grease.
The grease fitting locations and quantities are as
follows:
•
Pump-driveshaft U-joint (3)
Figure 36
•
Cutting-unit lift-arm cylinders (2 each)
Figure 37
(Figure 36)
g003962
(Figure 37)
g012150
•
Lift-arm pivots (1 each)
•
Cutting-unit carrier-frame and pivot (2 each)
(Figure 38)
•
Lift-arm pivot shaft (1 each)
•
Rear axle tie rod (2)
36
(Figure 37)
Figure 38
(Figure 39)
Figure 39
(Figure 40)
Figure 40
g003960
g004157
g003987