Setup; Adjusting The Tire Pressure - Toro Reelmaster 5410 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
Media and Additional Parts
Description
Operator's Manual
Engine Operator's Manual
Declaration of Conformity
Operator training material
Note:
Determine the left and right sides of the
machine from the normal operating position.
1

Adjusting the Tire Pressure

No Parts Required
Procedure
The tires are over-inflated for shipping. Therefore,
release some of the air to reduce the pressure.
Correct air pressure in the front and rear tires is 83
to 103 kPa (12 to 15 psi).
Important:
Maintain even pressure in all tires to
ensure that there is uniform contact with the turf.
Description
No parts required
No parts required
Right front hose guide
Left front hose guide
No parts required
Hood latch assembly
Washer
Cutting-unit kickstand
Qty.
–
–
1
1
–
1
1
1
Qty.
1
Read the manuals before operating the machine.
1
1 This document indicates conformity with certain standards.
1 Review the training material before operating the machine.
10
Use
Adjust the tire pressure.
Adjust the control-arm position.
Install the cutting units.
Adjust the turf-compensation spring.
Install the CE hood latch.
Install the cutting-unit kickstand.
Use