Traction Pedal; Brake Pedal; Parking Brake; Throttle Control - Toro Reelmaster 5410 Operator's Manual

Traction Pedal

The traction pedal (Figure
and reverse operation. Press the top of the pedal to
move the machine forward and the bottom to move
the machine backward. Ground speed depends on
how far you press the pedal. For no load, maximum
ground speed, fully press the pedal while the throttle
is in the F position.
AST
To stop the machine, reduce foot pressure on the
traction pedal and allow it to return to the center
position.
Figure 22
1. Traction pedal
2. Mow/transport lever
3. Mow-speed limiter and
spacers
Mow/Transport Lever
Use the mow/transport lever
machine into M mode or T
OW
the lever forward to select the M
backward to select the T
Note:
The cutting units cannot be lowered when the
mow/transport lever is in the T
Mow-Speed Limiter
When the mow-speed limiter
up/forward it limits the mow speed and allow the
cutting units to be engaged. Each spacer adjusts
the mowing speed by 0.8 km/h (0.5 mph). The more
spacers there are on the top of the bolt, the slower the
machine goes. Flip the mow speed limiter backward
to allow maximum transport speed.
22) controls the forward

4. Brake pedal

5. Parking brake

6. Tilt steering pedal
(Figure 22) to put the
mode. Push
RANSPORT
mode, and
OW
mode.
RANSPORT
position.
RANSPORT
(Figure 22) is flipped
Brake Pedal
Press the brake pedal
Parking Brake
To engage the parking brake,
on the brake pedal and press the top forward to latch
it. To release the parking brake, press the brake pedal
until the parking-brake latch retracts.
Tilt-Steering Pedal
To tilt the steering wheel towards you, press the foot
pedal (Figure 22) down, pull the steering tower toward
you to the most comfortable position, and release the
pedal.

Throttle Control

Move the throttle control
increase the engine speed and rearward to decrease
speed.
g003955
1. Lower mow/raise control
lever
2. Key switch
3. InfoCenter
Key Switch
The key switch
O /P , and S
N REHEAT
Lower Mow/Raise Control Lever
This lever (Figure
units and also starts and stops the cutting units when
the cutting units are enabled in the M
cannot lower the cutting units when the mow/transport
lever is in the T
17
(Figure 22) to stop the machine.
(Figure 22) push down
(Figure 23) forward to
Figure 23
4. Enable/disable switch
5. Throttle control
6. Headlight switch
(Figure 23) has 3 positions: O
.
TART
23) raises and lowers the cutting
OW
position.
RANSPORT
g025902
,
FF
mode. You