Comtech EF Data Memotec NetPerformer SDM-8400 Hardware Installation Manual page 32

NetPerformer SDM-8400 Hardware Installation Guide
1.
2.
3.
4.
5.
6.
3-10
Ensure that the SDM-8400 unit has successfully powered up with no system status
errors (see "System Status on Power-up" on page
Power the console terminal on or start your console terminal emulation program.
Take note of:
• "Important Console and Modem Settings for Startup" on page 3-9
• "Concerning HyperTerminal Connections" on page
When you see the prompt
console terminal keyboard several times, until the SDM-8400 responds with a prompt
for the user login.
Enter the administrator login:
This is the default login. Additional user logins can be defined. For details,
NOTE:
refer to the chapter Controlling Access to the NetPerformer in the Quick Con-
figuration section of the NetPerformer Reference Guides.
Enter the password for this login. The default password for the administrator login is
.
SETUP
When the password is entered correctly, the SDM-8400 sends the product banner to
the console screen, as in this example:
LOGIN:ADMIN
PASSWORD:*****
ACCEPTED
SDM-8400 vx.x.x Memotec Inc. (c) 2007
Signaling Engine x.x.x
Console connected on port CSL
B302417>
Enter the Display Alarms (
to verify that your unit is problem free. In particular, look for any alarm messages that
indicate
Call Technical Support
Type <ENTER> to connect
ADMIN .
) command at the NetPerformer console command line
DA
.
3-8).
8-1.
, press the key on the
<Enter>
Memotec