Omron Focus PM710-M Instruction Manual page 30

5. Troubleshooting
Problem
Therapy does
not start.
The adhesive
surface of the
pad does not
stick to skin.
The 1st, 3rd and
5th indicators
from the left
flash white.
If you are not able to solve your problem, contact 1-800-634-4350.
29
Possible cause
The pad is not placed
below your knee properly.
The device is not attached
to the pad properly.
Plastic films have not
been removed from the
adhesive surface of the
pad.
The pad is damaged.
Plastic films have not
been removed from the
adhesive surface of the
pad.
The pad or your skin is
wet.
The adhesive surface is
damaged.
There is too much hair on
your skin.
The pad was stored
under high temperature,
high humidity or direct
sunshine.
An error occurred.
Solution
Refer to sub-section 3.1 and place
correctly.
Remove the device from the pad,
then attach the device to the pad
properly. Refer to sub-section 2.2.
Peel off the film from the adhesive
surface of the pad.
Replace the pad.
Peel off the film from the adhesive
surface of the pad.
Air dry the adhesive surface of the
pad or your skin.
Replace the pad.
Shave the immediate area for
proper pad adhesion.
The pad is unable to be used due
to storage conditions. Replace the
pad.
Contact 1-800-634-4350.